[apacolypse]

I customized a couple 2.5" scale vehicles to fit 3.75" scale figures. Namely the Dragonhawk, Firebat, Vamp, and Iron Hammer mech.

They can be seen here with a how to guide: http://www.cobraisland.com/forums/showthread.php?t=510

Dragonhawk and Iron Hammer I think really work well with the 3.75" scale.

[DESTRO]

Nice work!

[Nemesis*Prime]

Your drivers and pilots look a little cramped.

[DESTRO]

Front Page...........

[C.I.A.D.]

It's because of Apac's work that I wanted to go out and snag these vehicles to convert for 3.75" purposes.....

I wouldn't say that the figures look too cramped at all, considering how much room there actually is scale wise.

The one vehicle that's a bit iffy is the Vamp. Nice size, but not every figure can fit inside of it. Then again, that can be said about most of the vehicles.

Still friggin' wicked work though, Apac

[Spirit-Iron_Lun]

Great stuff Apac and thanks for the how-to-guide

[C.I.A.D.]

Too bad the Street Razor is too small for conversion :(

[apacolypse]

Thanks fellas.

As for crampness...the vamp is like CIAD said...it depends on the figure. Ones with wide shoulders and legs with large packs on the sides do hinder another passenger. Some just fit better than others - sort of like a Slugger tank.

The firebat works best with a female pilot or again a figure with narrow shoulder span. I got a stinger driver to fit - but that just didn't seem correct for me, so I made a female pilot for it. Plus the way I see it - that is a high speed vehicle, so the cockpit has to be crampt.

The D-hawk has plenty of room - especially since the seat is for a 3.75" figure.

All in all...I'm happy with them. Some of them worked out better than others, but overall...the scale of them works very well with 3.75".

[bluebikerboy1]

thank you apac for posting this

[Shogi]

Quote:

Originally Posted by C.I.A.D.

Too bad the Street Razor is too small for conversion :(

Not really, if you treat it like Overlord's Dictator:

http://i29.photobucket.com/albums/c2...ms/S6Razor.jpg