View Full Version : Sigma 6 compatible with 3 34 in figurines
04-02-2010, 04:59 PM
Which Sigma 6 vehicles from Sigma 6 are compatible with 3 3/4 in figurines?
I bought the Sigma 6 R.O.C.C. and fit for the 3 3/4 in figurines exactly.
04-02-2010, 06:57 PM
And the Rhino.The Iron hammer and Dragonhawk will need new seats to fit them.
04-02-2010, 07:04 PM
Thanks Lt. Faceless
04-02-2010, 07:44 PM
The Rhino was from the 3 3/4" line called DTC
The Rocc made it's first appearance in the DTC line as well but when they brought it to Sigma 6 I don't think they changed anything.
The Copter Countdown (http://www.yojoe.com/sigma6/missionscale/toys/2006/coptercountdown/) vehicle works well with 3 3/4 joes if you take the two seats out of it. (note: it'll only fit one 3 3/4" figure in the cockpit)
The Razor's Edge (http://www.yojoe.com/sigma6/missionscale/toys/2006/razorsedge/) vehcile can sort of work. I took the canopy off and pulled out the seat to make it a one person vehicle, but the canopy can't go back on. It works like Overlord's vehicle in that sense
04-03-2010, 12:54 PM
The Iron Hammer, Dragonhawk, Night Ops Vamp (and arctic too I guess), Firebat, and the Cobra mech all are compatible.
You have to take the old seats out of all but the Cobra Mech.
I put a new seat in the Dragonhawk, but the top doesn't fully close, but no biggie.
You don't need to replace the seats, just take the old ones out.
07-01-2010, 05:57 AM
Sadly, I think it's only the Sigma 6 ROCC that is fully compatible with 3 3/4 figures. The reason for that is the ROCC was actually released under the DTC line and pre-dates the other Sigma 6 vehicle releases.
The other Sigma 6 vehicles, many of which I happen to like, usually require a lot of customizations, usually cockpit modifications to make them 3 3/4 friendly. In most cases, the fit is extremely tight though.
here are some pics for reference:
Iron Hammer (this is being re-released under the Pursuit of Cobra line and will be fully 3 3/4 figure friendly!)
07-01-2010, 06:04 AM
Here are a few more pics:
If you need reference as to how to do the conversions, you may want to refer to this other thread:
Hope this helps!
vBulletin® v3.8.7, Copyright ©2000-2013, vBulletin Solutions, Inc.
SEO by vBSEO